12
Assembly Instructions for Table-top Console
Tools required: Hex wrench (provided), Phillips screwdriver, stud finder, measure tape, pencil, power drill,
and 1/8” drill Bit (not provided).
17.
Position the assembled console at the desired location against a wall. In case of uneven floor, Floor
Levelers are provided at the bottom of both Legs (F and G). Simply tilt the unit back and raise or lower
Floor Leveler by hand to correct tilting, as shown above.
NOTE
: YOU MUST USE THIS TIPPING RESTRAINT TO ATTACH THIS UNIT TO THE WALL,
TO PREVENT THE UNIT FROM TIPPING, CAUSING ACCIDENTS AND/OR INJURIES.
18.
Now, follow the instructions printed on the plastic bag containing the Tipping Restraint Hardware to
attach the tip-over restraint to the Spine and the wall.
19.
The console is now ready for use. Be sure to position your Flat Panel TV in the center of the console.
NOTE
: If you choose the Wall Mount configuration,
proceed to PAGE
21.
TV
F
G
F/G
