WD-BF90 & WD-BF180
Rev. 5.0 (202201)
Installation
11
1.
Dishwasher
2.
Turn track
3.
Lock nut + washer
4.
Drive bar
5.
Sliding block
6.
Cover strip
7.
Screw + nut + washer
8.
Dishwasher loading cradle
The turn track is set to its default settings at the factory, but may need to be
adjusted according to the conditions at the place of installation.
•
The holes in the connection end of the turn track must fit against the hole
in the lower edge of the dishwasher’s outfeed opening.
•
Fit the cover strip (6) and screw the turn track and machine together using
the screws, washers and nuts provided (7).
•
Adjust the drive bar (4) so that the upper edge is at the same height as the
sliding surface on the machine’s loading cradle (8). The height of the drive
bar is adjusted by raising or lowering the stop rail attached to the end of the
turn track using the lock nuts at (3) and using the stop rail’s adjustable
support attached to the bottom plate of the turn track.
WDBF_11
2
1
1
2
3
4
5
6
7
8
Summary of Contents for WD-BF180
Page 2: ......
