WD-11
Rev. 5.0 (202206)
Operating instructions
47
4.3.3
Operating problems
Check:
•
Has the appliance been used according to the instructions?
•
Are all the removable parts in their correct place?
•
Is the main switch in the ON position?
•
Are there any error messages on the display?
•
Are the fuses in the electrical cabinet still intact? Ask service personnel to
check the fuses.
Troubleshooting
The following errors can be dealt with by the operator. If the problem persists,
contact authorised service personnel.
PROBLEM
CAUSE
ACTION
No indication on the control pan-
el display when the control but-
ton is pressed.
Power switch off.
Switch on the power switch.
The machine does not fill with
water.
The incoming water stopcock is
closed.
Open the tap.
The door/hood is open.
Close the door/hood.
The final rinse pipe nozzles are
blocked.
Clean the wash nozzles.
The machine fills slowly.
The final rinse pipe nozzles are
blocked.
Clean the wash nozzles.
The machine does not stop fill-
ing.
Level pipe or drain seal not in place.
Fit the level pipe or drain seal.
The level pipe or one of drain seals’
rubber sleeves are not sealing
against the bottom plate.
Check that the level pipe and drain
seals are closed. Replace the rubber
sleeves, if they are damaged.
The machine does not start
washing.
The door/hood is open.
Close the door/hood.
Dishware is blocking the magnet in
the door.
Remove the dishes in question.
Outward feed conveyor limit switch
has been activated.
Remove the basket from the limit
switch.
Noise from the washing pump.
Low water level. Foam in the tank.
Check the level. Change the water.
Summary of Contents for WD-11
Page 2: ......
