15
Set-up and Operation
Main Unit
The main unit consists of the LED spotlight (6), the motion sensor
(8) and the rechargeable battery. When you are planning the
installation location of the main unit, keep in mind that the motion
sensor that actives the light,
has a “field of vision” of approx.
12 meters in front of the light (for movements sidewise to the
motion sensor) and about 180º horizontally.
To mount the unit vertically for use as a security type of light,
attach the main unit to a solid surface as shown in figures A and
B. To mount the main unit horizontally for use as a convenience
type of light, attach the unit as shown in figure C. Use the
included screws or other suitable screws depending on the
consistency of the ground.
Solar Module
The solar module (4) is the power source for the LED lamp with
motion sensor. Make sure that the solar module is exposed to
DIRECT SUNLIGHT
for as long as possible.
Mounting and Start-up
1. For installing the main unit, use the included screws or other
suitable screws and wall plugs depending on the consistency
of the ground.
2. You can adjust the motion sensor horizontally and vertically.
For vertical adjustment, unscrew the wing screw at the joint of
the motion sensor and hand tight the wing screw after adjust-
ing the motion sensor. To adjust the motion sensor horizontally,
grasp the whole sensor and turn it very carefully to the left or
to the right to the desired position.
3. Connect the feed cable (2) of the solar module with the main
unit. Make sure to mount the main unit in a covered area so
water cannot enter the unit.
4. Set the AUTO/OFF switch (9) to the position
OFF
.
