15
Operating
Pair the wireless Foot Switch
Before first using the wireless foot switch (5), perform the following
steps to pair the wireless foot switch with the socket-outlet:
1. Plug the power plug (6) of the socket-outlet into a 230 V~ wall
socket.
2. Make sure the radio controlled sockets (1) are switched off and
the LED indicator does not shine.
3. Press and hold the on/off switch (3) for a few seconds until the
LED indicator slowly flashes.
4. Release the on/off switch and press it again until the LED
indicator rapidly flashes.
5. Release the on/off switch and operate the wireless foot switch
(5). The LED indicator goes off. Learning mode is finished. Foot
switch and socket-outlet are paired. This setting is permanently
stored.
Using the wireless Foot Switch
Operate the wireless foot switch (5) to apply voltage to the four
sockets (1). The LED indicator lights (2) up.
Operate the wireless foot switch (5) again to switch off the four
sockets (1). The LED indicator (2) goes off.
Note: The transmission range of the wireless foot switch is ap-
prox. 20 m. Keep in mind that the transmission range can be
reduced by obstacles such as walls of concrete and if 2 – 3 walls
are between the foot switch and the socket-outlet. If continuous
interferences occur, try to reposition the foot switch.
Deleting the Allocation
1. Plug the power plug (6) of the socket-outlet into a 230 V~ wall
socket.
2. Press and hold the on/off switch (3) for a few seconds until the
LED indicator (2) slowly flashes.
