![background image](http://html1.mh-extra.com/html/wet-sounds/stealth-6-ultra/stealth-6-ultra_user-manual_966501003.webp)
2.
INSTRUCTIONS FOR USING THE UNIT.
Press and hold the power button for 3-5 Seconds to turn the unit on.
Next, select what source you want to listen to, either Bluetooth or Auxiliary input.
Pairing with Bluetooth is easy, first press the source button on the unit until you see the
source indicator light flash blue, next turn on your blue tooth device and search for WS-
Stealth, then select it. That’s it! You are now paired with the unit.
NOTICE: You can only pair one device to the unit at a time. If the unit is not blinking
(indicating that it’s in pairing mode) make sure that it’s not connected to another device. If
you are connected and want to pair another device, first you must go to the settings in your
Bluetooth device and turn it off allowing the Stealth Ultra Soundbar to automatically search
for new devices.
Some unique features on the STEALTH ULTRA Soundbar when playing your Bluetooth de-
vice, you can use the buttons on the sound bar to control your device by advancing tracks
or replaying music on your device as well as volume. Also, by pressing the power button
on the unit it will pause your music on your device and by pressing it again it will allow the
device to continue playing. When the unit is selected in Auxiliary mode and the power but-
ton is pressed, the unit will mute the audio and un-mute the audio when pressed again.
When you are finished listening to music, simply press the power button and hold for 3-5
seconds and the unit will turn off. If the unit does not sense a signal from either the blue
tooth or auxiliary input for 10 minutes, it will automatically turn itself off.
INSTALLATION
A. Mounting
1.
Fit the appropriate tube clamp around the front strut in the desired location.
*Note: you
may need to remove bolts connecting the top to the front strut to complete this
step.
2.
If a sliding adapter was supplied in your kit, you will need to loosely fasten it to the
soundbar, and then to the round tube clamps installed in step 1.
3.
Ensure that the sound bar is in the desired location, then tighten all hardware.
B. Wiring
1. If installing on an electric vehicle,
switch it into TOW mode. Carefully remove the
Positive (+) then Negative (-) battery wires.
2. A. If installing on a gas vehicle,
wire the Negative (Black) wire to the Negative (-)
battery terminal and the Positive (Red) wire to the Positive (+) battery terminal.
B. If installing on an electric vehicle,
wire the Negative (Black) wire to the Ground on
the DC-DC Converter and the Positive (Red) wire to the Positive (+) post on the DC-DC
Converter.
3.
Route the blue Aux wires to your desired location.
4.
Tie up all excess wires and reinstall the Positive (+) then Negative (-) battery wires. If
installing on an electric vehicle, switch it back into RUN mode.
Note: DC-DC Converter is required on electric vehicles to avoid damage to the
accessory and the vehicle.