Step 6: Slide the wire jacket (13) down the wire and Butt Connect the speaker
wire coming from the tower to the speaker wire plug (4). Red is positive and
black is negative. If you have added the LED accessory, this speaker wire plug
(4) will have 6 conductors. Please refer to the LED install instructions.
Step 7: Attach Clamp Top (2) to clamp bottom (3) using the two Allen Bolts (2)
There are various length bolts included. There is 3 sizes. Small 30 mm length
that fits 1 ¾ to 2 ¼ inch sized pipe, medium 45 mm length that fits 2 ¼ to 2 ½
inch sized pipe and long 60 mm length that fits 2 ½ to 3 inch sized pipe.
Step 8: Make sure the clamp is tightened all the way so there is no movement
Step 9: The swivel clamp allows you to rotate the clamp slightly on the dual
clamp set up of the REV 410 to work on towers with slight curves. Then tighten
the bolt to lock it in place.
Step 10: The swivel clamp also allows you to remove the speaker from the
tower in seconds. Loosen the allen locking bolt (19) and remove the
detachment fork (17). Once removed, the speaker will disconnect from the
clamp. The clamp remains on the tower. To reinstall, line up the male speaker
plug (7) so that it is centered and insert the speaker by plugging the connector
together and reinstalling the detachment fork.
