Westwood V230D, Operator'S Manual, Page: 24 / 28

Troubleshooting (Electrical)
If “Seat Switch” appears where the
RPM display should be:
(Fig. 53)
p
This indicates the user has left the seat with the
park brake off.
p
The cutter will turn off after two seconds.
If “Overload” appears where the RPM
display should be:
p
This indicates that the control board has
detected a fault in one of the outputs and has
shutdown to protect itself.
p
To reset the board turn off the engine and
attempt re-start.
CONTACT YOUR DEALER IF THE PROBLEM
RE-OCCURS.
If “Switch Off” appears where the RPM
display should be:
(Fig. 54)
p
This indicates one of the above faults has
occurred.
p
Turn the ignition switch off.
CONTACT YOUR DEALER IMMEDIATELY AND
DO NOT ATTEMPT TO RESTART YOUR TRACTOR
AS SERIOUS DAMAGE MAY BE CAUSED
BY RUNNING THE ENGINE WITH LOW OIL
PRESSURE.
If “Start On” appears where the RPM
display should be:
(Fig. 55)
p
This indicates the start button is stuck on
immediately after the glow plugs are turned off.
p
The control board will wait until the start button
is released.
p
This may indicate a faulty start button. If so
contact your dealer
If “Brake” appears where the RPM
display should be:
(Fig. 56)
p
This indicates that when trying to re-start the
engine the park brake is off and should be put
on before re-starting the engine again.
If “Deck On” appears where the RPM
display should be:
(Fig. 57)
p
This indicates that when trying to re-start the
engine the cutter deck is on and should be dis-
engaged before re-starting the engine again.
Page 22
fig. 53
fig. 54
fig. 55
fig. 56
fig. 57