Westwood V230D, Operator'S Manual, Page: 18 / 28

Page 16
Troubleshooting (Cutter Levelling)
Levelling Side to Side
This adjustment is best done with the deck in a posi-
tion three up from its lowest cut – check the level both
sides and levelling is then achieved by adjusting the
left side ( as you are sat on the Tractor) of the deck at
2 points.
Rear adjustment
(Fig. 39)
Locate the top lock nut (A) and loosen this off using a
17mm Spanner. Now wind the adjuster nut (B) either
up or down using a 19mm Spanner to alter the height
of the deck on the left hand side to match that on the
right hand side. Use the marks on the plate as a guide
as to how much to raise or lower the deck. When the
deck is level at the rear tighten the lock nut securely
Front adjustment
(Fig. 40)
Locate the top lock nut (A) and loosen this off using a
17mm Spanner. Now wind the adjuster nut (B) either
up or down using a 19mm Spanner to alter the height
of the deck on the left hand side to match that on
the right hand side. Use the marks on the plate as
a guide as to how much to raise or lower the deck.
When the deck is level at the front tighten the lock nut
securely. Raise and then lower the cutter deck and
then re-check the level. If it is still incorrect re adjust
as required.
A
Front Adjustment
fig. 40
B
A
B
Manual Deck Lift
fig. 39