Westweld LTD
Office:
No.51, Xuefu Avenue, Nanan, Chongqing 400074 , China
12
enable switch on the touch screen, press the power off button on the front panel. Close the power
switch on the back of the machine, put the welding head back to the host placement.
3.3 Parameter setting
Figure 5
1. The home page shows the adjusted process parameters shown in Figure 5, click "Technology"
enter the parameters setting. Adjust the above parameters according to the Process Parameters
Table. There are 9 parameters card, it can save parameters according to their own different welding
products.
2. After setting the parameters, click "Save", and then click "Import" click "Back" to home page.
Figure 6
Figure 6
3. To adjust the red light, you need to check whether the red light is in the center of the outlet of
the welding nozzle. If there is a left-right offset, you need to click the "Settings" button to adjust.
The first step is to click "Settings" and enter the password:123456 to enter as shown in the figure 7,
adjust the left and right movement of the red light by adjusting the laser center offset, the negative
number of "-" means the light goes to the left.
