Auger
Driver
GRINDING INSTRUCTIONS
11
ENGLISH INSTRUCTIONS
1. Remove the Ring Nut, Grinding Plate,
Knife and Auger from the Grinder Head
before installing the Grinder Head to the
Main Body.
2. Align the notches in the Grinder Head
with the tabs on the Main Body.
3. Press the Grinder Head against the
Motor and rotate it counterclockwise until it
locks into place
(FIGURE F)
.
4. Insert the Auger into the Grinder Head,
Auger Driver end first
(FIGURE G).
5. Place the Grinder Knife onto the square
portion of the Auger Pin. The cutting edges
(flat side) of the Knife should be facing out.
6. Place the Grinding Plate of your choice
onto the Auger Pin. Make sure the notch of
the Grinder Plate fits into the positioning pin
of the Grinder Head.
7. Insert the Stuffing Funnel through the
Ring Nut and then onto the Grinder Head.
8. Turn the Ring Nut clockwise onto the
threaded end of the Grinder Head until it
touches the Stuffing Funnel. DO NOT over-
tighten the Ring Nut.
9. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder
without the Tray installed!
FIGURE F
FIGURE G
READ AND FULLY
UNDERSTAND ALL
INSTRUCTIONS AND
WARNINGS PRIOR
TO USING THIS UNIT.
Never leave this appliance
unattended!
WARNING!
WARNING!
Before cleaning, assembling or disassembling the
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
STUFFER ASSEMBLY
