8. Align the Bracket
Arm, under the nothes
on the 2-Speed Motor
(FIGURE 4).
9. Slide the two 110mm
Bolts through the holes
in the Bracket Arm then
through the holes in the
Motor Bracket
(FIGURE
4).
10. Screw the two Wing
Nuts onto the ends of
the 110mm Bolts and
tighten until the 2-Speed
Motor is secured in
place
(FIGURE 5).
Note: DO NOT over tighten the Wing Nuts,
tighten only enough to secure the 2-Speed
Motor firmly into place. If the Wing
Nuts are to tight, the 2-Speed Motor may
bind during use.
11. The 2-Speed Motor is now fully
assembled and ready for use. Be sure to
read and understand the instructions that
came with your cuber/jerky slicer for safe
operation.
FIGURE 4
FIGURE 5
Wing Nuts
110mm Bolts
Bracket
Arm
Notches on
2-Speed
Motor
6
ENGLISH INSTRUCTIONS
