Westinghouse WP2500, Owner'S Manual, Page: 18 / 110

18
ASSEMBLY
14. Connect the high-pressure hose to the pump and
tighten the hose fi tting (see Figure 16) . Do not
overtighten. The fi tting only needs to be hand-tight.
1
2
Figure 16 – Installing High-Pressure Hose WP2500
Shown
1 - Soap Hose 2 - Hose Fitting
15. Connect the soap hose to the barbed fi tting if you
are going to be using soap (see Figure 16) .
16. Flip the trigger lock up to lock the trigger in the OFF
position (see Figure 17) .
1
2
Figure 17 – Trigger Lock in OFF Position
1 - Trigger Lock 2 - Hose Fitting
17. Install the high-pressure hose to the spray gun
and tighten the hose fi tting (see Figure 17) . Do not
overtighten. The fi tting only needs to be hand-tight.
ASSEMBLY – WP3000Z
Before assembling the pressure
washer, review
Safety on page 7
and the following safety messages.
!
CAUTION
Never lift the pressure washer without
assistance. The pressure washer is
heavy and lifting without assistance
could result in personal injury.
!
Never use the handles as a lifting point
to support the entire weight of the
pressure washer. Only use the handles
to move the pressure washer by lifting
the handles and using the wheels to
move the pressure washer.
Use caution when collapsing the
handles. Hands and fi ngers could get
caught and pinched.
NOTICE
Assembling the pressure washer will require tipping
the unit. Make sure all engine oil and fuel are drained
from the unit prior to assembling.
Once assembled, the wheels are not intended for
on-road use. The wheels are designed for use on this
pressure washer only.
Never tip the pressure washer after it has been fully
assembled and fi lled with oil and fuel.
1. Place pressure washer on a fl at surface.
2. Install the upper handle to the frame using the
handle bolts and knobs (see Figure 18) .