Westinghouse WHG952SB, User Manual

Page: 5 / 11

8 9
NOTE: Distances shown to adjacent walls/surfaces are for the distance to a combustible surface. If the surface is
not combustible the measurement can be smaller than that shown.
Figure 4 - Installation cut-outs
C
B
D min
A min
INSTALLATION INSTRUCTIONS TECHNICAL DATA
FEATURES WHG756SA WHG952SB WHG956SA
Cooking zones 5 5 5
Wok Yes Yes Yes
Ignition 220-240V 220-240V 220-240V
Trivet Cast Wire Cast
Hob material Stainless steel Stainless steel Stainless steel
Features Ignition through knob Ignition through knob Ignition through knob
Flame safeguard Yes Yes Yes
Colours Stainless steel Stainless steel Stainless steel
Gas Types NG, (LP conversion
kit supplied)
NG, (LP conversion
kit supplied)
NG, (LP conversion
kit supplied)
Cooktop
dimension (mm)
Width
745 895 895
Depth 530 530 530
Height* 50 50 50
Cutout
dimension (mm)
Width
730 880 880
Depth 490 490 490
Energy rating
(NG) - MJ/h
Small burner
5.1 5.1 5.1
Medium burner 2 x 9.0 2 x 9.0 2 x 9.0
Large burner 12.1 12.1 12.1
Wok burner 14.4 14.4 14.4
Total MJ/h 49.6 49.6 49.6
*Height is distance from the top of the kitchen bench to the bottom of the cooktop
INSTALLATION INSTRUCTIONS
MODEL CODE
DIMENSION (MM)
GAS SUPPLY
LOCATION
A B C D (LEFT OR RIGHT)
WHG644SA 143 560 490 145 Left
WHG646SA 143 560 490 145 Left
WHG756SA 146 730 490 145 Left
WHG952SB 121 880 490 145 Left
WHG956SA 121 880 490 145 Left
This appliance must be installed by an authorised person
and in compliance with:
1. AS/NZS 5601.1 Gas Installations Part 1: General
Installations, and AS/NZS 5601.2 Gas Installations
Part 2: LP Gas installations in caravans and boats for
non-propulsive purposes, or the relevant installation
code for gas appliances in your country.
2. The local gas fitting regulations, municipal building
codes, electrical wiring regulations and any other
relevant statutory regulations.
3. The particular instructions as given below.
WARNING
CAUTION
Cooktops are supplied for use with natural gas (NG).
To use with LPG the injectors MUST be changed using
the conversion kit supplied. Refer LP Conversion on page
12 and 13.
4. A certificate of compliance MUST be given to the
customer after the appliance is successfully installed.
5. This appliance must be earthed.
TECHNICAL DATA (CONTINUED)