Westinghouse JSG16-8CD, Instruction Manual, Page: 9 / 18

INSTALLATION
Installation of flue
•
This product is Forced Exhaust and supply gas water heater, it can be used before exhausting
the waste gas to the outdoor according to the strict requirement. It’s not allow to use the gas
water heater without operating the flue correctly.
• Fix the elbow and the straight pipe together, and wrap and seal the joint by aluminum foil
sticker. (Fig. 12)
• Install the flue after the heater body is fixed. First, put the fixed flue through the hole in the
wall, then insert the elbow into the exhaust outlet of the heater smoothly, the flue end should
have a 2º downward inclination (Fig. 12b(, otherwise the rain may flow into the heater and
damage it.
• The power of the heater is 120V, 60 Hz/AC, the power socket must have a reliable ground wire,
and with a switch is much better . If there is water leakage near the power cord, move it to a
suitable place (Fig. 8)
Installation methods
•
Drill holes on the wall according to the dimension of Fig. 2, fix with expansion bolts in the
upper hole and fit the lower hole with plastic cock, hang uo the heater and use a self-tapping
screw fix the lower hole of the heater.
• The height is suitable when the flame check window is in the same level with eyesight
(1.5-1.65m above the ground) (Fig. 10).
•No visible electric wire and electric appliance is permitted above the heater, the horizontal
distance between the heater and the electric appliance should be more than 400mm. The
distance between the heater and the flammable subject should not be less than the dimension
shown as Fig. 11.
Fig. 9(b) 10K, 12K
Fig. 10
(Notes: flamenproof board should be 100mm bigger
than the heater)
Fig. 11
flaneproof
board
indoors outdoors
the min thickness