Westinghouse JSG16-8CD, Instruction Manual, Page: 11 / 18

wrong installation problem caused correct installation
exhaust gas
leak into room
adnormal
combustion
work abnormally
outdoors
outdoors
common
flue
INSTALLATION
Fig. 14
• The 10K, 12K, very thin model has the flue connection, so it won’t be install the flue.
• Installation of water and gas pipe
• It can be used when the flue system can insure that the provided gas pressure can reach the
lowest requirement. If gas water heater reach the rated heat input, the gas pressure must
reach the rated heat input in the technologic parameter form. Gas rated pressure bellows:
Natural Gas 13mbar.
• Gas inlet
(1) For LPG, use a gas rubber pipe with inner diameter 9.5mm to connect, put one end into
the gas inlet of the heater, the other into the reducer outlet of the gas tank, insert the pipe
into the inlet and outlet completely and use a clip to tight it.
(2) For TG’ ask gas dealer to connect a suitable gas rubber pipe according to the character of
the gas used.
(3) After connecting rubber
pipe, check leakage with
soapsuds. Cold water inlet.
Use flexible or rigid pipe to
connect with the water inlet.
Install a water valve before the
water inlet. (Fig. 15)
• Hot water outlet
Use a flexible or rigid pipe to conect with the sprayer without valve. If a valve or switch is
connected to the sprayer, the outlet pipe shall not use heat and pressure unendurable
material like plastics, aluminum pipes, so as to avoid the pipe break and scald user.