CAUTIONS FOR SAFETY
Prevent Eyes From Getting Hurt
Keep eyes away from the flame indicator window at a minimum safety distance
of 300mm during ignition. If the first attempt of ignition fails, wait 10-20
seconds before the next attempt.
Prevent No-water Burning In The Heater
After each shower, make sure that the flame is extinguished when the valve
is closed. If the flame still exists after the water valve is closed, something
must be wrong with the heater. Switch off the gas valve immediately and
contact the service center. Otherwise the heater may be damaged by overheating
and then may cause fire accident.
Freezing Prevention
Under low temperature, drain the water remaining in the heater after each use
completely. Otherwise the water may freeze and expand to damage the heater.
Reduce The Chance Of Encrustation
After shower and turning off the gas valve, drain out the hot water in the gas
cylinder until cool water is out. Then turn off the water inlet valve.
Do Not Use The Heater Water For Drinking
As there is always residuce in the heater, the water supplied by the heater is
only for general use, not for drinking.
Dealing With The Abnormal Conditions
*
Stop the heater when there is strong adverse wind blowing into the bathroom
from outside causing the heater unable to operate.
•
In case of abnormal burning (c.g. flame back, flamcout, yellow flame or black
smoke, etc.), unusual smell, noise or other abnormal matters, keep calm and
turn off the gas valve and contact the service center or the gas dealer.
Preventing Overheating Scald
•
After shower, or when the water temperature control knob is still at “high”
position, be careful of the temperature of the water at the beginning and ending
of shower, as ir may remain high to scald your skin.
•
During or right after shower, so not touch any part of the heater other than
the control knobs, especially the parts around the flame check window.
The Following Things Are Normal
•
When the water pressure is lower than 0.03MPa, the heater cannot be ignited.
•
The drain valve is dripping. When the water pressure is too high, the drain
valve will release the water so as to reduce the pressure to protect the heater.
Summary of Contents for HT351G12
Page 14: ......
