GS-26-RS23-WH21
11
L
N
N
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
1. Turn off power at circuit box to avoid possible electric shock.
2. Removing mounting plate (B) from fixture back plate (G) and save alen screws (A) for late use.
3. Place mounting plate (B) flush against wall at desired mounting location. Using outside
mounting plate hole (I) as a guide, mark where pilot holes are to be drilled.
NOTE: Mounting plate (B) holes must be straight for fixture to hang straight.
4. Inset two plastic anchors (D) into the pilot holes (for drywall).
5. Thread fixtures wires through mounting plate hole (H) for later electrical connections usage.
6. Align outside mounting plate holes with plastic anchors (D) (If applicable). Secure mounting
plate (B) into place using washer (C) and wood screws (E).
7. Make an electrical connection by loosening the terminal screws on the terminal block (F) and
inserting the live, neutral terminals.
8. Tighten terminal screws. Make sure there are no stray wires.
9. Position back plate (G) over mounting plate (B) by aligning back plate openings on edges on
back plate with the screw holes on mounting plate (B).
10. Replace alen screws (A) onto the edge of back plate (G).
11. Turn power back on at circuit box.
MOUNTING AND WIRING INSTRUCTIONS
FIGURE 1.
D
I
H
B
A
E
C
G
F
Summary of Contents for 61149
Page 26: ...GS 26 RS23 WH21 26...
