2
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-212329-RevD
ECO #: W16-0082
DATE: 2/16/17
2. Starting at the front driver side mounting location. The
bottom rocker mounting hole may be covered by black
tape. After removal, insert M10 nut plate through the
square hole. Some vehicles may already be equipped
with a threaded hole. See
Figure 1.
3. Attach the driver front mounting bracket to the vehicle un-
derbody using (1) M10 hex cap screw, (1) M10 split lock
washer, and (1) M10 flat washer. See
Figure 2.
4. Attach the driver side front support bracket to the pinch
weld of the vehicle using (2) M8 hex cap screws, (4) M8
flat washers, (2) M8 split lock washers, and (2) M8 hex
nuts. One more holes located on the pinch weld may have
to be enlarged using a 5/16”-3/8” drill bit. See
Figure 2.
5. Secure the support bracket to the main mounting bracket
using (1) M8 hex cap screw, (2) M8 flat washers, (1) M8
split lock washer, and (1) M8 hex nut. See
Figure 2.
Do
not fully tighten mounting & support brackets at this time.
6. Repeat
Steps 3-5
for the driver center and rear mounting
bracket and support bracket. See
Figure 3.
Do not fully tighten at this time.
Figure 2
Figure 3
Item 18
Front
Figure 1
