W
ESTFIELD
- G
RAIN
A
UGERS
3. A
SSEMBLY
MK 130 P
LUS
X
61’ - 81’
30259
41
4. Thoroughly
lubricate
the
angle drive, then replace access doors. Keep angle
drive well lubricated (after every 8 hours of operation) with high-temperature
grease.
Important:
Check alignment! You should be able to rotate the hopper flight by hand.
Note:
The angle drive requires a break-in period of at least 2 to 3 loads.
5. Clean any dirt or paint from the wheel axles on the hopper bottom.
6. Install the 2 wheels to the hopper bottom with a washer and cotter pin each.
Figure 3.29
NOTICE
To prevent damage, you must maintain the correct angle
when inserting flight shaft end into angle drive until tube is
secured to the hopper section. Allowing tube or hopper to
drop will bend the flight shaft end causing it to bind in the
angle drive.
Summary of Contents for MK 130 PLUS 71
