W
ESTFIELD
- G
RAIN
A
UGERS
3. A
SSEMBLY
WR 60/80/100 X 26’ - 71’ EMD M
ODEL
3.14. T
RANSPORT
U
NDERCARRIAGE
30255 R3
33
Note:
Installing tires may not leave you with enough clearance to position and attach undercar-
riage once auger tube is raised. If so, install wheels after assembly is complete.
g. Check that pressure of pre-inflated tires matches pressure indicated on tire
sidewall. Mount wheels on hubs and attach with six 1/2” x 1-3/4” wheel bolts.
7. Fasten upper lift
arms to lower
reach arms with 5/
8
”
x 1-1/2
”
bolts
and locknuts.
Do
not overtighten
.
Tighten snug only.
These bolts act as
pivot points.
• The 6" x 61', 8"
x 56’-61’-71'
and the 10" x
51’-61’-71'
augers require
3/4” x 2" bolts
and locknuts.
8. Raise
the
discharge end of auger with a front end loader
and a strong sling/chain or block and tackle.
The height should be sufficient to clear
undercarriage assembly.
Do not remove tube support until
auger is fully assembled.
9. Position
transport
undercarriage
beneath tube
assembly and attach
lower reach arms
(Figure 3.18) or
extension arms
(Figure 3.17) to
reach arm bracket on
bottom tube with 5/8”
x 1-1/2” bolts and
locknuts.
Do not
overtighten
. Tighten
snug only; these
bolts act as pivot
points.
Figure 3.17
Figure 3.18
