Westfalia OSD 6-91-067, Instruction Manual

Page: 143 / 206

Westfalia Separator
Mineraloil Systems GmbH
143
2058-9001-101 / 0506
Fig. 232
•
Insert gasket 1 in the groove in the
lower section of frame.
•
Fit rubber-metal cushion 2.
Pay attention to the correct fitting
position of the rubber-metal cush-
ion!
The two opposite inner holes 3 of
the rubber-metal cushion must be
directed upwards .
Fig. 233
•
Turn spindle through 180
o
(upside
down).
•
Mount bearing covers 1 and 2.
Pay attention to the correct fitting
position of the bearing cover!
•
Grooved ball bearing 3
– Heat in oil to 80
o
C and
– slide onto the spindle.
•
Insert retaining ring 4 in the spindle
groove.
Fig. 234
•
Ball bearing protection ring 1
grooved ball bearing 2, and angular
contact ball bearing 3 :
– Heat in oil to 80
o
C and
– slide onto the spindle.
Bearing damage is caused by incor-
rect fitting!
•
When fitting angular contact ball
bearing 3 on the spindle, make sure
that the
narrow rim of the ball bear-
ing inner ring faces upwards to the
spindle end.
Fig. 235
•
Install the assembled spindle as-
sembly 1 in the lower section of
frame and
•
Bolt tight with the three hex head
screws 2.