15
11.
OPERATING INSTRUCTIONS
Charger Operation
NOTE:
Once automatic charging or flash reprogramming has started, the
buttons will not work until you turn off the output, with the exception of the
Start/Stop ( ) button. (In MANUAL mode the “UP” and “DOWN”
( and ) buttons also still operate normally.) When the display shows
OFF
,
no buttons will work for five seconds as the charger automatically goes back to
the default settings.
Automatic Charging
1.
Connect the battery and AC power following the precautions listed
in sections 6, 7 and 8.
2.
Set the MODE to AUTOMATIC CHARGE.
3.
Set the BATTERY TYPE to STANDARD or GEL CELL.
4.
Set the CHARGE RATE to 4A, 20A or 70A.
5.
Press the Start/Stop ( ) button when you are ready to start
charging.
6.
The CHARGING ( ) LED will light yellow.
NOTE:
Automatic charging starts only if the CONNECTED ( )
LED is lit yellow and the battery has at least a 1V charge. If the battery
is less than 1V, press and hold the Start/Stop ( ) button for five
seconds to start Auto¬matic Charging, or charge it in Manual mode for
five minutes then switch back to Automatic Charge.
7.
The CHARGED ( ) LED will light when charging is complete
and the charger has gone into maintain mode.
Manual Charging
1.
Connect the battery and AC power following the precautions listed
in sections 6, 7 and 8.
2.
Set the MODE to MANUAL CHARGE. (The TIME LED will start
blinking.)
3.
Use “UP” and “DOWN” ( and ) buttons to set the time
(shown in minutes) you want the charger to charge the battery. Set
to to run the charger without a time limit.