![background image](http://html1.mh-extra.com/html/westfalia/82-55-79/82-55-79_instruction-manual_963594015.webp)
11
Operation
Introduction
This new user friendly ultrasonic animal repeller provides you a convenient,
non-location limited and human way to deter the cats, dogs, rabbits and
field rodents out of your garden.
By means of a motion sensor, the animal repeller monitors a fan shaped
area of 120° angular degrees and a distance up to 10 m. As soon as
creatures enter the protecting area, the animal repeller will project ultrason-
ic sound waves at frequency ranges of 17, 23 or 40 kHz in order to deter
the intruding creatures. This frequency cannot be heard by humans but for
animals it is very disturbing and therefore they will leave or avoid the
protecting area quickly.
The ultrasonic animal repeller is splash-proof and can be operated indoors
and outdoors in any weather conditions.
Assembling and Mounting
The ultrasonic animal repeller comes with a ground stake (12), a mounting
plate (11) and with a swivel bracket (10).
The swivel bracket can be installed at the bottom side of the housing of the
animal repeller. For this, slide the swivel bracket between both bars.
Alternatively the swivel bracket can also be installed at the rear side of the
unit respectively at the rear side of the battery box. Use 4 small screws for
installation. Before installing the swivel bracket to the battery box, it might
be necessary to remove the hanging bracket (2x screws) from the battery
box.
The mounting plate (11) can be fastened on a wall, on a wooden post or
even on the ceiling. In combination with the swivel bracket, the unit can be
tilted to all directions in order to align the desired protecting area.
Using the ground stake (12) the ultrasonic animal repeller can be installed
at an ideal height above the ground. Assemble the single parts that corre-
spond to the ground stake as pictured on page IV and slide the mounting
plate of the ground stake on the bracket on the bottom side of the animal
repeller. Always insert the spiky part of the ground stake completely into
the soil to ensure a secure grip.
Use the supplied wall plugs and screws to install the ultrasonic animal
repeller on the wall. Drill two holes in a distance of 78 mm. Insert the wall
plugs and turn in the screws. Then use the hanging bracket to hang the unit
on the screws.