12
Operation
When using the drain pipe cleaner for
opening exterior drains
, pay attention
to the water level. The system must be full of water. Add water to the system if
necessary.
For drain systems with multiple openings begin by using the drain pipe cleaner
closest to clog while plugging all adjacent openings.
Repeat steps as necessary with each of the other openings upstream until the
drain system flows normally.
Using
1. Prepare the drain pipe cleaner as described in chapter “
Assembling
”.
2. When using the drain pipe cleaner on any exposed drain traps, be sure to
support the bottom of the trap with a strong, non-flexible object, e.g. a sturdy
pot, a book, etc. The drain pipe cleaner uses air pressure to work. Failure to
support any exposed drain trap may result in the drain pipe fitting become
loose due to the compression. Unexposed drain traps used in showers, bath
tubs, etc. do not need support.
3. Put the drain pipe cleaner on a firm and flat surface. Use the pump lever (7) to
pump air into the air reservoir (3). Pump until you feel a strong resistance
(normally this occurs after approx. 20 to 30 strokes).
4. Run water in the obstructed drain until the water level reaches the drain
opening. Place the drain pipe cleaner on the blocked drain opening. A
pressure-resistant sealing is important.
5. Firmly hold the drain pipe cleaner with both hands. One hand holds the air
reservoir (3) and the other hand holds the handle (5). Quickly press the trigger
(4). The air rapidly escapes from the air reservoir through the clogged pipe and
clears the obstruction in the drain.
6. Slowly lift the drain pipe cleaner from the drainage and immediately flush with
plenty of running water. If necessary, repeat the process several times to
remove stubborn obstructions.
7. Uncover all previously closed overflow openings.
Notes:
Use the drain pipe cleaner periodically even when there is no heavy
obstruction. This helps precautionary prevent any obstructions.
When grease and debris are collected on the inside of the drain pipe walls,
pour a mixture of hot water and detergent into the drain before using the drain
pipe cleaner.
After using the drain pipe cleaner, check if all tubes of the drain system are still
firmly connected.
