11
Mounting and Using
GENCY interior release and connect the wire with the wire
connector (2).
Use pliers and squeeze the wire connector in order to se-
curely fasten the wire.
Make sure not to overtighten the wire. Ask a second person
to assist you while checking functionality. Do not leave the
garage and do not close the garage door with the garage
door opener unless you have tested proper function of the
additional EMERGENCY release.
Hint: Make sure not to bend the wire. Also make sure the
garage door is not touching the garage door frame too tight.
Otherwise the pressure on the frame will be very high and
thus will lead to high power requirement for releasing the
garage door.
Mounting on a door with large material thickness:
The socket with the male thread (4) of the EMERGENCY
release is shorter than the thickness of the garage door.
1. Mark the drilling place. The external through-hole must be
25 mm. Drill the hole from the external side of the garage
door for the socket with the male thread (4). Now drill a hole
with a diameter of approx. 55 mm from the rear side of the
garage door, so the male thread of the socket will be barely
visible. The hole must have a diameter of 55 mm, to be able
to fasten the hexagon nuts (3) with a socket insert of the
size 41 mm.
2. Proceed like described in point 2 in the chapter “Mounting
the additional EMERGENCY release”.
3. Make sure not to overtighten the wire.