8
Using
Unloading
Perform the following steps to unload and to remove a trap gun
that did not shoot:
The unit has to be secured by two safety devices.
1. Put the locking clip (C) over the bolt lever (E).
2. Insert the locking pin (G) into the provided hole at the end of
the bolt lever (E).
3. Unscrew the cartridge holder (B).
4. Remove the cartridge (H).
Trapping Instruction
1.
Hoe up the vole
mounds on several
locations.
2.
Open the runs by
means of a wooden
stick in every hoed up
mounds. The runs must
not have any curves or junctions. They have to run straight
for approx. 20 cm.
3. After a short period of time the shade-loving vole will close
the run that is inhabited by it.
4. Open this run again.
5. Put the loaded trap gun approximately 3 cm inside the run.
6. When setting up the trap gun make sure that enough light
can enter besides the trap gun and the trigger ring (A) can
run freely from any obstacles.