Document: 1846en06.doc
Auth.: TAn
Date: 2011-12-29
Page: 4 av 17
WESTERSTRAND URFABRIK AB
Box 133
Tel. 0506 48 000
Internet::
www.westerstrand.se
545 23 TÖREBODA
Fax. 0506 48 051
E-mail:
The Temperature sensor is not included. It is an option.
The programming of the time and temperature display is made by buttons at the computer board or via
remote control.
The digital clock can operate stand alone with a built in quartz crystal as time reference, as a slave
clock to a master clock transmitting 24 V polarised 1/1 minute impulses or synchronised by TC, DCF.
If the DLS-function is set , the clock is changing, summer and winter time, the last Sunday in March
and the last Sunday in October automatically.
The clock has adjustable light intensity.
If power failure occurs the display is turned off. The internal clock continues to keep the correct time
for 48 hours. After power failure the display is turned on and correct time is shown.
.
Installation{TC \l1 "Installation}
Mount the clock by means of the mounting brackets. Both wall and roof mounting is possible by
rotating the brackets.
To open the clock, slide the front glass by loosening the aluminium profile on the short side of the
clock. Unscrew 2 screws and open the service plate.
Connect the synchronisation source if present (radio, impulse etc). See the connection diagrams,
page 5.
See also the configuration instructions for setting of synchronisation (page. 6 and 8.)
Connect the mains, 230VAC 50Hz . Installation fuse max 10A.
The socket outlet shall be installed near the clock and shall be easily accessible.
When the clock is installed permanently, a readily accessible disconnect device (2-polar, 3 mm
contact gap) shall be incorporated in the fixed wiring.
Set correct time and date according to the programming instructions on page 10.