Lit. No. 79551, Rev. 07
85
June 15, 2022
CUTTING EDGE WEAR AND
LEVELING ADJUSTMENT
MVP PLUS™ & MVP 3™ Cutting Edges
After the snowplow has been installed on the
vehicle in the correct configuration, a fine
adjustment can be made to bring the cutting
edges in full contact with the ground across the
entire cutting edge. This adjustment should be
done as the cutting edges begin to wear, in order
to maintain an even wear pattern across both
cutting edges and provide good scraping action.
1. Snowplow must be installed on a properly
ballasted vehicle, in the correct configuration.
MAINTENANCE
2. Vehicle and snowplow must be on a level surface.
3. If the optional shoe kit has been installed
on the blade, remove the shoes during this
adjustment procedure.
4. Place the blade wings in scoop position on the
ground with no tension on the lift chains.
5. Remove and retain the rear fasteners holding
pushbeam to T‑frame. Loosen the front
fasteners and allow the blade to find a level
position.
WARNING
Keep 8' (2.4 m) clear of the blade when it
is being raised, lowered, or angled. Do not
stand between vehicle and blade or directly
in front of blade. If the blade hits or drops
on you, you could be seriously injured.
MVP 3
snowplow
shown
T‑Frame
Pushbeam
Rear Fasteners
Front
Fasteners
Summary of Contents for UltreMount 2
Page 3: ......
