August 1, 2006
6
Lit. No. 27554, Rev. 08
27550
7/16-20 Nut
Star
Washer
7/16-20 Nut
Blade
Guide
6. Add a trip bumper to each end of the pivot tube as
shown below. The round boss on the bumper will fit
into the pivot tube, and the long bumper leg will butt
up against the upward bend of the quadrant. Place
a 5/16" flat washer on a 5/16" x 5" cap screw, and
slide the cap screw through bumpers. Attach a 5/
16" flat washer and a 5/16" locknut to the cap
screw, and tighten until the rubber on the bumpers
begins to dimple.
7. Place the blade in the upright position so that the A-
frame is sitting on the floor. Place the plow gear into
position straddled over the A-frame. Align the lower
holes in the plow gear with the holes in the A-frame
pushears. Attach the A-frame to the plow gear with
two 3/4" pins and two 5/32" cotter pins.
Jack
Square Vinyl Cap
Jack Handle
Jack Sleeve
Plow Gear
Jack
3/4" Pin
Plow Gear
A-Frame
5/32" Cotter Pin
8. Assemble the jacks. Place the jack through the
jack sleeve, and tighten the threaded jack handle.
Add a square vinyl cap to the top of each jack leg.
9. Attach the jacks to the plow gear. Position the jack
sleeves so the jacks will keep the plow gear upright
and the A-frame parallel to the ground while the
remaining components are attached.
10. Remove end moldboard fasteners (a T45 TORX
®
driver is needed) and discard. Install a blade guide
on each end of the blade as shown. Ream holes if
necessary.
TORX
®
is a registered (
®
) trademark of Textron, Inc.
5/16"
Flat Washer
5/16" x 5"
Cap Screw
Trip Bumper
Pivot Tube
Trip Bumper
5/16"
Flat Washer
5/16"
Locknut
A-Frame
