Westermo RFI-207-F4G-T3G, User Manual

Page: 24 / 32

24 6641-22310
F4G-T4G, 4 SFP slots and 4 Gbit copper ports
The F4G-T4G interface has four SFP slots supporting Ethernet BaseFX/X and four RJ-45
connectors supporting Ethernet 10/100/1000BaseTX/T. Each SFP slot can
hold one SFP transceiver for copper or fibre cable. Fibre transceiver distances range
from 550 m (0.34 mi) to 120 km (74,6 mi).
For supported transceivers see section on SFP transceivers.
All ports support category 5e cable or better and can handle cable lengths up to 150 m
(492 ft).
Interface specifications
F4G-T4G
Fixed copper ports (RJ-45)
Electrical specification IEEE std 802.3. 2005 Edition
Data rate 10, 100 or 1000 Mbit/s
Duplex Full or half, manual or auto
Circuit type TNV-1
Transmisson range Up to 150 m with CAT5e cable or better*
Isolation to All other
Connection RJ-45 auto MDI/MDI-X
Shielded cable Not required, except when installed in Railway applications
assignalling and telecommunications apparatus and located
close to rails*
Conductive housing Yes
Number of ports 4
* NOTE! Railway installation close to the rails.
To minimise the risk of interference, a shielded cable is recommended when the cable is located
inside 3 m boundary to the rails and connected to this port.
The cable shield should be properly connected (360°) to an earthing point within 1 m from this
port. This earthing point should have a low impedance connection to the conductive enclosure of
the apparatus cabinet, or similar, where the unit is built-in. This conductive enclosure should be
connected to the earthing system of an installation and may be directly connected to the protective
earth. Refer also to "Safety" section.
SFP ports
Optical/Electrical specification IEEE std 802.3. 2005 Edition
Data rate 10, 100 or 1000 Mbit/s*
Duplex Full or half, manual or auto
Transmission range Depending on transceiver
Connection SFP slot holding fibre transceiver or copper transceiver
Number of ports 4
* 100 Mbit/s or 1000 Mbit/s transceiver supported.