47
4.3
Port Configuration
Port Configuration group enables you to enable/disable port state, or configure
port auto-negotiation, speed, and duplex, flow control, rate limit control and port
aggregation settings. It also allows you to view port status and aggregation
information.
Following commands are included in this section:
4.3.1
Port Control
4.3.2
Port Status
4.3.3 Rate Control
4.3.4 Storm Control
4.3.5
Port Trunking
4.3.6
Command Lines for Port Configuration
4.3.1
Port Control
Port Control commands allow you to enable/disable port state, or configure the
port auto-negotiation, speed, duplex and flow control.
Select the port you want to configure and make changes to the port.
In
State
column, you can enable or disable the state of this port. Once you
disable the port stop to link to the other end and stop to forward any traffic. The
default setting is Enable which means all the ports are workable when you
receive the device.
In
Speed/Duplex
column, you can configure port speed and duplex mode of this
port. Below are the selections you can choose:
Fast Ethernet Port: AutoNegotiation, 10M Full Duplex(10 Full), 10M Half
