14
6643-22701
Interface specifications, 100/1000SFP
Optical/Electrical specification
IEEE std 802.3. 2005 Edition
Data rate
100 Mbit/s or 1000 Mbit/s transceivers supported
Duplex
Full or Auto, depending on transceiver
Transmission range
Depending on tranceiver
Connection
SFP slot holding fibre transceiver or copper transceiver
Number of ports
1 or 2
Interface specifications, RS-232
Electrical specification
EIA RS-232
Data rate
300 bit/s – 115.2 kbit/s
Data format
7 or 8 data bits, Odd, even or none parity, 1 or 2 stop bits
Protocol
Transparent, optimised by packing algorithm
Circuit type
SELV
Transmission range
15 m / 49 ft
Isolation to
All other
Connection
RJ-45 according to EIA-561
Shielded cable
Recommended
Conductive housing
Yes
Number of ports
1
Interface specifications, RS-422/485
Electrical specification
Configurable for EIA RS-232 or EIA RS-422/485
Data rate
50 bit/s – 2 Mbit/s
Data format
7 or 8 data bits, Odd, even or none parity, 1 or 2 stop bits
(2 stop bits only when no parity is set)
Circuit type
TNV-1
Transmission range
Up to 1200 m / 0.74 mi, depending on data rate and cable
type
Isolation to
All other
Connection
RJ-45 according to EIA-561
Shielded cable
Not required, but recommended in railway installations close
to the rails.*
Conductive housing
Yes
Number of ports
1
* To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m
boundary or the cable is longer than 30 m and inside 10 m boundary to the rails and connected to this port.
