Owner’s Manual
14
TIP:
The RF power / drive control on the radio is not set to maximum causing
the PC not to have enough audio to drive the radio even to half output.
TIP:
The RF power / drive control on the radio is not set to maximum causing
the drive stages and ALC to distort your signal causing it to be wide and
distorted. Set the RF drive to maximum and turn down the audio drive to
the desired RF power level.
TIP:
Low impedance headphones or speakers are loading down the audio
output from the sound card. Disconnect them or replace them with amplified
PC speakers or PC headphones.
Please understand that the
RIGblaster Plus II
will not work if the software
and PC do not work. Make sure that you have your software operating
properly and your sound card adjusted properly to expect your station with
the
RIGblaster Plus II
to work. You must read the documentation (Help
files) that comes with the software. With over 150
RIGblaster
compatible
programs, we cannot include software instructions in this manual. Also we
did not write the software and we cannot properly support it. It is suggested
that if experiencing software problems, try a different program.
If you have audio problems with two or more sound card programs, not
necessarily ham radio programs, you may have a problem with your
Windows
®
sound card driver software installation, not your sound card
hardware.
For additional support information go to:
http://www.westmountainradio.com/supportpnp.htm
NOTE: If you contact us for support we must have the number of the
step of this manual that you ran into a problem on. We may not be
able to help you without this information.
It is best to call us while you are at your station rather than try to
communicate with us by email. Our support desk is available 8:30 AM
to 5 PM Central Time Zone, Monday through Friday.
