PTT LOOP JUMPER
– P5
The PTT LOOP JUMPER is used to loop PTT directly inside the
RIGblaster Pro
or, if desired,
externally via a sequencer or other device. The factory default is with a Direct Blue Shunt
jumper installed on the P5 jumper block.
RECEIVE AUDIO CONNECTION OPTIONS
This section describes the three most common ways of getting audio from the radio to the
Computer Sound Card. Note that only one method may be used at any given time.
Method 1
In this example, audio is taken from the External Speaker jack of the radio, routed to the
RIGblaster Pro
, then onto both the PC and the Radio External Speaker. The only downside to
this method is that the audio level is dependent on the AF Gain setting and, thus, may require
adjustment each time during operation.
Method 2
In this example, fixed level audio (unaffected by the setting of the AF Gain setting) is taken
from the Accessory, the phone patch or data out jack of the radio and routed to the
RIGblaster
Pro
, then onto the computer Sound Card. The advantage of this method is that the audio level
is fixed, requiring little, if any, adjustment of the audio settings after initial setup.
Summary of Contents for RIGblaster Pro
Page 30: ......