69
CAUSE
You are on a channel
which is limited to 1
watt transmit power
(e.g. Ch. 13) or you
are on a "receive
only" channel (e.g.
WX).
CAUSE 1: No
cahnnels are in the
scan memory.
CAUSE 2: Squelch is
not adjusted correctly.
The transmit power is
set to low.
SYMPTOM
You can not change the
transmit power setting.
The SCAN key does
not start the scan
function.
You can hear
transmissions, but the
other radio cannot hear
you.
REMEDY
Change to an unrestricted
TX/RX channel.
REMEDY 1: Use the
MEM/UIC key to enter
desired channels into the
scan memory.
REMEDY 2: Adjust the
squelch to the point that
background noise just
disappears.
Use the H/L/MENU key to
select a higher transmit
power setting.
UT01920ZB_0 8/16/05 12:34 PM Page 69
