21
3. Packaging, storage and transport
3.1 Delivery status
The machine is supplied completely pre-assembled. The corresponding operating fluids (e.g. refrigerant) are
already contained.
3.2 Packaging and transport
After unwrapping the machine, keep the original packaging if possible. If the machine has to be dispatched (e.g.
return for repair), the original packaging should be used if possible. Please indicate the position of the machine
within the packaging on the outside of the packaging. ( „
↑
Top
↑
“ )
If the machine has to be dispatched or relocated, please also note the instructions in the previous sections.
CAUTION:
In order to completely empty the water from the ice production trough, please turn off the machine
(push the production switch -see Fig. 5.5-, located on the upper side inside the storage bin, to the right). If ice
cubes are present on the evaporator fingers, please wait until these detach of their own accord and fall into the
storage container. Now remove the ice cubes from the storage container and wipe out the container with a cloth
in order to remove residual moisture. Dismount the machine, close off the water supply, pull out the power plug
and separate all hose connections.
3.3 Storage
If your machine is not immediately installed or commissioned after delivery or relocation, it should be stored in a
dry
place and at
temperatures above freezing
.
4. Technical data and machine description
4.1 Identification
The identification plate is located inside the device on the cover plate of the equipment set. A further nameplate
is located behind the front panel on the right outer side of the storage bin (underneath the pushbutton for
power).
The CE mark is located at the identification plate of the ice cube maker.
The information provided on the identification plate matches the machine specification (see page 3).
4.2 Machine equipment and accessories
The ice cube maker is standard supplied with:
•
operating instructions, installation instruction for front metal sheet;
•
screwed connection, gasket and circlip, installation instruction for water inlet;
•
outlet hose, plastic angle and hose clip;
•
slide-in tray, installation instruction for slide-in tray;
•
ice
scoop.
4.3 Noise level
The continuous sound pressure level emitted by the machine is < 46 dB(A).
Depending on local conditions, higher sound pressure levels may occur.
E
N
G
L
I
S
C
H
E
N
G
L
I
S
H
A
N
G
L
A
I
S
