HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedalling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (47) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions at the left
and remove the left side shield.
Next, turn the
resistance knob
to the lowest set-
ting. Locate and
open the Strap
Buckle (46). Grip
the end of the
Resistance Strap
(47) and pull it up
to remove any
slack. Whilst
holding the end
of the Resistance Strap, fully close the Strap Buckle.
Turn the Crank (17) for a moment to make sure that
there is not too much resistance. When the Resis-
tance Strap is properly adjusted, reattach the left side
shield and pedal.
HOW TO ADJUST THE BELT
The exercise cycle features a precision belt that must
be kept properly adjusted. If the belt causes exces-
sive noise or slips as you pedal, the belt should be
checked. To do this, the left side shield must first be
removed. Refer to the instructions on page 12 and
remove the left
side shield.
Next, use an
adjustable
wrench to turn
the right pedal
counterclock-
wise and
remove it.
Remove the
right side
shield.
Press down on the centre of the Belt (16) between the
front and rear sprockets. There should be from 1/4”
to 3/4” of vertical movement in the centre of the
Belt.
If the Belt (16)
is properly
adjusted, reat-
tach the side
shields and ped-
als. If the Belt
needs to be
adjusted, loosen
the M10
Washer Nut
(34) on each
side of the
Flywheel (39). To tighten the Belt, turn the two M6
Nuts (37) clockwise; to loosen the belt, turn the Nuts
counterclockwise. Make sure that the Flywheel is
straight and tighten the M10 Washer Nuts (34). Reattach
the side shields and pedals.
13
4
BEFORE YOU BEGIN
Thank you for selecting the new WESLO PURSUIT
®
895i exercise cycle. The PURSUIT 895i blends
advanced engineering with contemporary styling to
provide you with a low-impact workout in the conve-
nience and privacy of your own home.
For your benefit, read this manual carefully before
you use the PURSUIT 895i. If you have additional
questions, please call our Customer Service
Department at 0345-089009. To help us assist you,
please mention the product model number and serial
number when calling. The model number is
WLEX69871. The serial number can be found on a
decal attached to the PURSUIT 895i (see the front
cover of this manual for the location of the decal).
Before reading further, please look at the drawing
below and familiarise yourself with the parts that are
labelled.
Handlebars
Resistance Knob
FRONT
BACK
RIGHT SIDE
Seat Knob
Seat
Book Rack
Seat Post
Pedal
Console
Water Bottle Holder
(bottle is not included)
Front Wheels
46
17
47
16
16
39
34
37
