6
5. Peel the backing off one of the Pedal Covers (27).
Center the Pedal Cover on the plate on the Left
Leg (3). Press the Pedal Cover firmly in place.
Attach the other Pedal Cover (27) to the plate on
the Right Leg (4) in the same manner.
8. Attach the Right Leg Cover (31) to the Right Leg
(4) with a Tree Fastener (32).
Attach the Left Leg Cover (30) to the Left Leg (3)
in the same manner.
Slide the 3/8Ó Lock Washer (58) onto the Lock
Knob (25). Insert the Lock Knob into the hole near
the top of the Right Leg (4). Tighten the Lock
Knob into the Right Pivot Bracket (8).
6. Refer to figure 6b. The Electronic Monitor (37)
requires two ÒAAÓ batteries (not included). Press
the tab on the battery cover and remove the bat-
tery cover. Insert two new ÒAAÓ batteries into the
Monitor.
Make sure that the batteries are turned
as shown.
Replace the battery cover.
Remove the two indicated #8 x 3/4Ó Screws (23)
from the Right Upright (2). Attach the Monitor
Bracket (45) to the Right Upright with the Screws.
Note: If the Electronic Monitor (37) does not oper-
ate properly, see HOW TO ADJUST THE REED
SWITCH on page 8.
7. Slide one of the Handles (13) onto the Left Leg
(3). Attach the Handle with two 1/4Ó x 1 1/2Ó Bolts
(60) and two 1/4Ó Nylon Locknuts (59).
Attach the other Handle (13) to the Right Leg (4)
in the same manner.
Note: Extra 3/8Ó Axle Caps (40) may be included.
Before you use the AIR STRIDER, firmly retight-
en all of the parts used in assembly.
Fig. 7
Fig. 6a
45
23
13
Holes
60
59
3
4
13
2
37
37
Batteries
Battery
Cover
31
30
4
8
3
32
25
58
Fig. 8
Fig. 5
Fig. 6b
27
3
4
27
