6
7. Attach the Seat (12) to the Seat Post (5) with three M8
Nylon Locknuts (10) and three M8 Flat Washers (51).
Note: The Nylon Locknuts and Flat Washers may be
preattached to the underside of the Seat.
6. Whilst another person holds the Upright (13) in the
position shown, connect the console wire to the Reed
Switch Wire (43). Next, connect the console cable to
the Lower Cable (45) in the following way:
• See inset drawing A. Pull up on the metal bracket (A)
on the Lower Cable (45), and insert the tip of the
console cable (B) into the wire clip inside of the
metal bracket.
• See inset drawing B. Firmly pull the console cable
(B) and slide it into the metal bracket (A) on the
Lower Cable (45) as shown.
• See inset drawing C. Using pliers, squeeze the
prongs on the upper end of the metal bracket (A)
together.
Carefully push the excess wire and cable down into the
Frame (1), and insert the Upright (13) into the Frame.
Be careful to avoid pinching the wires and cables.
Next, attach the Upright to the Frame with two M8 Split
Washers (53) and two M8 x 15mm Button Screws (54).
13
Console Wire
43
1
45
54
53
54
53
6
Console Cable
7
51
12
51
10
10
5
Be careful
to avoid
pinching the
wires.
A
B
C
45
B
B
A
A
A
45
