13
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent.
IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim or if the console
does not function correctly, the batteries should be
replaced; most console problems are the result of low
batteries. To replace the batteries, see assembly step
7 on page 8.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left pedal, the upright covers, and the left
shield must be removed.
Using an adjustable wrench, turn the left pedal clock-
wise and remove it. Next, remove the screws from the
upright covers and the shields. Then, carefully remove
the upright covers and the left shield.
Next, turn the resistance knob to the lowest setting.
With the left shield removed, locate the Reed Switch
(39). Turn the Crank (21) until the Magnet (38) is
aligned with the Reed Switch. Loosen, but do not
remove, the M5 x 15mm Screw (47). Then, slide the
Reed Switch slightly closer to or away from the
Magnet, and tighten the Screw. Turn the Crank for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjusted,
reattach the left shield, the upright covers, and the left
pedal.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
belt may need to be adjusted. See HOW TO ADJUST
THE REED SWITCH at the left and remove the left
pedal, the upright covers, and the left shield.
To adjust the belt, you must also remove the right
pedal and the right shield. Using an adjustable
wrench, turn the right pedal counterclockwise and
remove it. Then, carefully remove the right shield.
Next, loosen the two 3/8" Nuts (27), one on each side
of the Flywheel (37). Then, tighten the M6 Locknuts
(32), one on each side of the Flywheel, until the Belt
(35) is properly tightened. Finally, tighten the 3/8” Nuts
(27) and reattach the shields, the upright covers, and
the pedals.
MAINTENANCE AND TROUBLESHOOTING
21
47
39
38
35
37
32
27
Meijer.com
Summary of Contents for PURSUIT S 2.8
Page 16: ...16 NOTES Meijer com ...
Page 17: ...17 NOTES Meijer com ...
