Weslo Gym 1000, Manual

Page: 9 / 27

9
12
48 21
50
7
6
58
12. Route the Long Cable (58) around a “V”-Pulley
(6). Attach the Pulley and the Long Cable Trap
(50) to the Right Arm (48) with an M10 x 60mm
Bolt (7) and an M10 Nylon Locknut (21). Make
sure that the Cable is in the groove of the
Pulley and that a Long Cable Trap (50) is
turned to hold the Cable in place.
13. Refer to the inset drawing. Attach the Pulley
Bracket (20) to the bracket on the Top Frame (55)
with an M8 x 115mm Bolt (64) and an M8 Nylon
Locknut (3). Note: The Pulley Bracket is pre-
assembled with a 90mm Pulley (15) and a
Cable Trap (66).
Route the Long Cable (58) around the 90mm
Pulley (15) attached to the Pulley Bracket (20).
Make sure that the Cable is in the groove of
the Pulley and that the Cable Trap (66) is
turned to hold the Cable in place. Make sure
that the M10 x 45mm Bolt (12), securing the
Pulley and Cable Trap to the Pulley Bracket, is
properly tightened and that the Pulley Bracket
can pivot freely.
13
58
66
15
71
20
64
55
3
20
11
10
50
58
7
47
58
21
7
21
6
50
6
42
10. Wrap the Long Cable (58) around a “V”-Pulley
(6). Attach the Pulley and a Long Cable Trap (50)
to the bracket on the Front Upright (42) with an
M10 x 60mm Bolt (7) and an M10 Nylon Locknut
(21). Make sure that the Cable Trap is posi-
tioned to hold the Cable in the groove of the
Pulley.
11. Route the Long Cable (58) around a “V”-Pulley
(6). Attach the Pulley and a Long Cable Trap (50)
to the Left Arm (47) with M10 x 60mm Bolt (7)
and an M10 Nylon Locknut (21). Make sure that
the Cable is in the groove of the Pulley, and
that the Cable Trap is positioned to hold the
Cable in place.