HOW TO ADJUST THE DRIVE BELT
If the Drive Belt (32) slips as you exercise on the
ECLIPSE II, the Drive Belt should be adjusted. To
adjust the Drive Belt, the side shield must first be
removed. Refer to the instructions on page 10 and
remove the side shield.
Next, loosen
the two M8
Flange Nuts
(23) (there is
one on each
side of the
Flywheel [20]).
To tighten the
Drive Belt (32),
turn the two
M6 Nuts (26)
clockwise; to
loosen the
Drive Belt, turn the M6 Nuts counterclockwise. Make
sure that the Flywheel is straight and retighten the M8
Flange Nuts (23). When the Drive Belt is properly
adjusted, reattach the Side Shield and the Crank
Arms.
HOW TO TIGHTEN THE CRANK
If the Crank Arms (10) become loose, they should be
tightened in order to prevent excessive wear. Loosen
the Crank Nut
(17) on the left
Crank Arm.
Place the end
of a standard
screwdriver in
one of the slots
in the Slotted
Crank Nut (15).
Lightly tap the
screwdriver with
a hammer to
turn the Slotted
Crank Nut coun-
terclockwise until the arms are no longer loose.
Do
not overtighten the Slotted Crank Nut.
When the
Slotted Crank Nut is properly tightened, retighten the
Crank Nut.
11
20
23
26
32
17
15
