14
17
18
19.
Make sure that all parts of the elliptical are properly tightened.
Note: Some hardware may be left over
after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical.
17. Apply grease to the axle on the right Disc
Crossbar (16) and to a Large Wave Washer
(76).
Slide the Large Wave Washer (76) and the
Right Pedal Arm (12) onto the right Disc
Crossbar (16).
Tighten an M10 x 25mm Patch Screw (40) and
an M10 Washer (83) into the Right Disc
Crossbar (16).
Then, press a Pedal Arm Cap (74) into the
Right Pedal Arm (12).
Repeat this step on the other side of the
elliptical.
18. Apply grease to an M6 Bolt Set (25).
Hold the end of the Right Pedal Arm (12) inside
the bracket on the right Upper Body Leg (5).
Attach the right Upper Body Leg (5) to the Right
Pedal Arm (12) with the M6 Bolt Set (25).
Do
not overtighten the Bolt Set; the right Upper
Body Leg must pivot freely.
Identify the Left and Right Upper Body Leg
Covers (80, 89), which are marked with “Left”
and “Right” stickers, and orient them as shown.
Press the tabs on the Left and Right Upper
Body Leg Covers (80, 89) together to attach
them around the right Upper Body Leg (5).
Repeat this step on the other side of the
elliptical.
See step 6.
Tighten the M10 x 20mm Patch
Screws (7).
74
40
83
12
76
16
5
89
25
12
80
25
Grease
Grease
