Wesco WS6427, Manual, Page: 12 / 15

12
EN
9. BENDING PLASTIC TUBE
Choose the Hook nozzle and fit over heat outlet. Turn the
gun upside down and place on its clip stand so that it is
resting on a secure bench with the nozzle pointing upwards,
see picture. To avoid buckling or kinking the tube, fill the
tube with dry sand and seal at both ends. Heat the tube
evenly by moving from side to side and bend to required
shape.
WARNING: Protect hands from heat.
MAINTENANCE
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may
see sparks through the ventilation slots. This is normal and
will not damage your power tool.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
TROUBLE SHOOTING
1. If your heat gun will not operate, check the power at the
mains plug.
2. If the outlet of the heat gun very hot, please rest until
cold.
3. If a fault can not be rectified return the tool to an
authorized dealer for repair.