Wesco PBP1803, Manual

Page: 17 / 28

17
EN
ATTENTION:
The spindle lock button must only
be used when changing a pad. Never press it when
the pad is rotating.
Remove the plug from the socket before
carrying out the adjustment.
8. TO USE THE ROTATE HANDLE (SEE FIG. H)
To best suit the different working positions, your polisher
is equipped with a turnable handle. Press the rear of the
locking button on the turnable handle and you can rotate the
handle 90
0
to left or right. Then release the locking button.
A click will be heard, when the handle is then fully locked
in place.
9. TO REPLACE THE BRUSHES (SEE FIG. I)
Remove the brush holder out directly by screwing the
screwdriver. Check the length of the brush and replace if
under 4mm. When brushes need replacement always renew
both brushes, even if one is still more than 4mm long. Put
the brush holder into the body. Tighten the brush holder.
Check the tool is working before use, allow it run for a few
minutes to enable the brushes to be stable.
10. TO USE THE CAR POLISHER (SEE FIG. J)
Hold extension cord over the shoulder and do flat surfaces
first, i.e.: bonnet boot and roof. Cover areas quickly with
broad sweeping strokes in a crisscross pattern. Do not press
down on polisher. The machine without any pressure will
automatically do the best job.
11. FINAL WORK (SEE FIG. K)
Use long, sweeping strokes in a criss-cross pattern to bring
out the shine. Do not over-press the polisher.
WORKING HINTS FOR
YOUR POLISHER
1. At all times, let the polisher do the work-do not force it
or apply excessive pressure to the polisher. Preferably,
use a light circular motion. Pressing too hard will slow
down the machine’s movement and affect the quality of
the work.
2. The most common error, however, is applying too much
wax. If pad absorbs too much wax, it will not last as
long, and polishing is more difficult and takes longer.
3. If bonnet continually comes off pad, please try with a
new bonnet.
4. If wax seems difficult to buff, you may have used too
much wax.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store
your power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation
slots. This is normal.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
TROUBLESHOOTING
1. If your power tool does not start, check the plug on the
power supply first.
2. If the polisher does not abrade surface, checking the
bonnet. If the bonnet has been worn, replace the new
bonnet and try again.
3. If a fault can not be rectified, return the tool to an
authorized dealer for repair.