Page
6
of
26
©Copyright 2018 WESCO Industrial Products, LLC. Specifications subject to change. Not responsible for errors or omissions.
Electric Non-Telescoping High Lift Truck
(Part # 272460 & 272461)
Instruction Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR HIGH LIFT TRUCK,
READ THESE INSTRUCTIONS ENTIRELY BEFORE USING.
6. BATTERY CHARGING AND REPLACEMENT (CONTINUED)
6.3 Charging
Using Onboard Charger
• The attached automatic charger is only available for the optional voltage of 110V or 220V as referred.
• The exactly charge status can be only checked from the discharge indicator. To control the status, the
charging must be interrupted and the truck must be started.
• Park the truck at a dedicated secured area with a dedicated power supply. Lower the forks and
remove the load. Switch the truck off and connect the main power connector to the power supply. The
charger starts charging the battery.
• This Charger features a three-stage charging function with automatic switching from 1
st
stage to the
next stage.
Stage 1: Constant current charging
Stage 2: Constant voltage charging
Stage 3: Floating charging
Following the increase of the electricity in the battery, the charging electrical current is reducing, the
charger steps into the 3rd stage automatically.
1.) SPECIFICATIONS
Input Volt: 150 – 260 V, AC 50 – 60 Hz
Output Volt: 145 V ±0.3
Output Current: 5 – 6 Amp
Applicable Ambient Temperature: –15 - +65
2.) OPERATION
a. Insert the plug of the power cable into the socket of the power line. The Power Indicator lights (red)
and then Charging Indicator turns on red, indicating the battery is in charging.
b. When Charging Indicator turns from red to green, the battery is nearly full. Charging can continue in
the Floating Stage.
c. When the battery is fully charged, disconnect the Power Cable from the Power Line.
3.) WARNING
a. During charging the truck can’t be lifted electrically!
b. Do not use the truck in wet areas or conditions.
Table 3: Charging LED
LED- Signal
Function
Red Battery
discharged
Green Fully
charged
When charging is finished, disconnect the connector from the socket and place it in the designated
pocket.
External Charger
The external charger automatically selects the charging state according to the detected battery voltage
and converts into floating charge state when the battery is fully charged.
Disconnect the Emergency plug and connect the charger plug with the battery sided connector.
Connect the power cord of the charger to the main power supply. After switching on the charger, the
charging starts automatically.
