WERKU WK500470, Original Instructions Manual

Page: 3 / 40

English
ENG
ORIGINAL INSTRUCTIONS
3
in moving parts. If there are devices for connecting
means for extracting and collecting dust, make sure
they are connected and properly used. The use of
these devices can reduce dust related hazards.
CONNECTIONS AND AIR TYPE.
Quick connections should be used for connections
with the compressed air system and male non-wa-
tertight sleeve must be installed in the paint spray
gun so that no air is compressed after the discon-
nection. Never use oxygen, combustible gases or
any other bottled gases. Never use oxygen tanks,
fuel gas, etc. as a power source for the paint spray
gun. Use of these gases or other bottled gases is
dangerous, because the paint spray gun could ex-
plode. Use only clean, dry and regulated compres-
sed air.
MAXIMUM PRESSURE.
The paint spray gun should be connected to a sou-
rce of compressed air if the pressure does not ex-
ceeded more than 10% the maximum allowable
pressure of the paint spray gun; in case of higher
pressures a pressure reducing valve should be
installed, including a valve-up downstream in the
supply of compressed air.
DO NOT POINT THE PAINT SPRAY GUN.
Never aim it at yourself or others, being the paint
spray gun loaded or not. Never play with the paint
spray gun, use the paint spray gun as a professio-
nal tool.
STORE PNEUMATIC TOOLS.
Store pneumatic tools out of reach of children and not
allow the handling of pneumatic tools to people unfa-
miliar with the tools or these instructions. Pneumatic
tools are dangerous in the hands of untrained users.
MAINTENANCE.
Check moving parts for misalignment or binding,
there are no broken parts or other conditions that
may affect the operation of pneumatic tools. Pneu-
matic tools are repaired before use when they are
damaged. Many accidents are caused by poorly
maintained pneumatic tools. Use pneumatic tools,
accessories and tool tips, etc. according to these
instructions and in the manner provided for the par-
ticular type of pneumatic tool, taking into account
the conditions work and work to develop. The use
of the pneumatic tool for applications other than
those intended could result in a dangerous situa-
tion. Please check your pneumatic tool serviced by
a Werku
®
official repair service using only identical
replacement parts. This will ensure the safety of the
pneumatic tool is maintained.
CHECK CONDITION.
Make sure that all the screws in the paint spray gun
are perfectly tightened. In cold climates or when
the paint spray gun has not been used for a period,
allow the paint spray gun to warm up by leaving it to
run empty for a few minutes, to ensure that all inter-
nal components are perfectly lubricated. Make sure
that the possible installed accessories are perfectly
fitted in place.
BEFORE STARTING WORK.
Make sure that the suction paint spray gun is firmly
supported before using. Check that no one is stan-
ding beneath you when using the suction paint spray
gun in high areas. Keep your hands away from all
moving parts of the suction paint spray gun.
DURING THE OPERATION.
Do not leave the suction paint spray gun operating
without having it firmly fixed. Only turn it on when
you are sure you have full control over it. Do not
point the suction paint spray gun at anyone while in
use. When operating the suction paint spray gun will
produce vibrations. The screws may gradually come
loose, and possibly cause faults or accidents. Keep
your hands away from all moving parts of the suction
paint spray gun.
AT FINISH WORKING.
Do not touch the possible accessories installed in
the suction paint spray gun after use. It may be hot
and cause burns. Some materials worked with may