23
Industrial Communication
Diagnostic I/O: Short-circuit after Gnd (going)
Api
0x00000000
Slot
0x0001
Subslot
0x0001
Channel
1: (Port2, Pin2)
2: (Port2, Pin4)
3: (Port4, Pin2)
4: (Port4, Pin4)
AlarmSpecifier
0x02, Diagnosis disappears
ChannelErrorType
0x0101, (manufacturer-specific)
8. Web-based Configuration
The switch is equipped with a web-based setting interface, which works independently of the operating system.
You can easily set parameters for the switch using a standard web browser. The network settings are preset to
the IP address 192.168.100.1, subnet mask 255.255.255.0 and standard gateway 192.168.100.254. The preset
values are always assumed in the instructions.
The web server allows control-independent monitoring or a test environment to be set up. It is not needed for
normal operation on the controller.
Attention:
When using on a controller, settings changed through the website are overwritten by the controller.
8.1. Call up the Administration Interface
Start the web browser. Enter the IP address of the switch into the address line of your browser and press the
ENTER key. The IP address of the switch is preset to 192.168.100.1. To ensure that the browser displays the
current website settings, the website in question must always be refreshed automatically in case of change.
This setting must be changed browser-specific and is demonstrated here by means of Internet Explorer as an
example. Under
Extras
Internet Options
Browsing history
Settings
the selection should be set to
Every time I visit the webpage.
Otherwise, any changes to the homepage might be displayed incorrectly.
