Wenglor P1PY1 Series, Operating Instructions Manual

Page: 9 / 38

9 Long-Range Laser Distance Sensors
Order No.
Technical Data
P1PY
101 111 102 103 113 104 107 108
Setting range 50 – 10,000 mm —
Measuring range — 50 – 10,000 mm
Switching hysteresis < 15 mm —
Current consumption (operat-
ing voltage = 24 V)
< 35 mA < 40 mA
Switching frequency 50 Hz* —
Response time 15 ms —
Measuring rate — 100/s*
Acceleration sensor — Yes — — Yes — —
Connection diagram no. 243 241 242
Connection type 1x M12; 5-pin
Cable with
1×M12
5-pin plug
1×M12; 5-pin
Cable with
1×M12
5-pin plug
1×M12;
5-pin
1×M12;
5-pin
Cable length (L) — 500 mm — 500 mm — —
Output function 2× PNP NO 2× NPN NO
Analog
0 – 10 V
Analog
4 – 20 mA
MTTFd (EN ISO 13849-1) 574,59 a 543,26 a 574,59 a 574,59 a 543,26 a 574,59 a 508,83 a 512,61 a
Depends on mode, see chapter “3.4 Mode-Dependent Data” on page 10
3.2 Warm-up phase
The warm-up phase lasts 6 minutes. The switching on drift during that time can be seen in the following
diagram.
0 60 120 180 240 300
–7
–5
–6
–4
–3
–2
Time in sec.
Typ. deviation in mm
–1
Switching On Drift
360
0
NOTE!
Specifiations related to the measured value without load. For the analog versions this spec-
ification can deviate due to the load on the analog output.